Building the Best Ultrasonic Cleaning Equipment for Over Forty Years
Quick Contact Request a Quote

Applications

Quick Jump:

Your Challenge

To clean chips and oils from tubes and components prior to brazing operation, and remove flux and clean fuel rails after brazing with a fully automated machine that does not require an operator.

  • Clean chips and oils from tubes and components prior to brazing operation
  • Remove flux and clean fuel rails after brazing
  • Fully automated operation, no operator available

How We Solve It

Machine Type:

Process:

Using a VAR Parts Washer with automated handling load and unload, micron filtration and a rotating recirculating-air dryer, parts are vertically agitated and rotated in solution and rotated out of solution to drain prior to transfer to a rinse and passivate cycle, two rinse and inhibit cycles, and then a complete drying cycle.

Benefits

This system removes all contaminants and flakes off of parts, inhibits and protects against oxidation, finishes with a spot-free dry, and cleans less than .0002g per 25 square inch or surface area [ID and OD with largest particle smaller than 200 x 150 x 100 microns].